This research study is focused on providing FEA analysis of a formula student car steering knuckle uprights to check the factor of safety. The model was designed in Solidworks®️ 2018 version and static structural analysis was carried out in Ansys®️ Workbench 2019 R3. Steering Knuckle uprights are used to connect steering tie rods suspension arms to wheel assembly(HUB) and also hold brake calipers. Being part of a wheel, it is always in motion and sustains too much load. So it needs to be stiff at the same time as lightweight as possible. The material used for knuckle is Aluminium 7075 T6. Total deformation of 0.1752 mm was observed. Results are fairly reliable and can be utilized to go further with the manufacturing of the knuckle uprights.